Melt Adsorption as a Manufacturing Method for Fine Particles of Wax Matrices without Any Agglomerates


We have focused on melt adsorption as manufacture method of wax matrices to control particles size of granules more easily than melt granulation. The purpose of present study was to investigate the possibility of identifying a hydrophobic material with a low melting point, currently used as a meltable binder of melt granulation, to apply as a novel carrier in melt adsorption. Glyceryl monostearate (GM) and stearic acid (SA) were selected as candidate hydrophobic materials with low melting points. Neusilin US2 (US2), with a particle diameter of around 100 µm was selected as a surface adsorbent, while dibasic calcium phosphate dihydrate (DCPD), was used as a non-adsorbent control to prepare melting granules as a standard for comparison. We prepared granules containing ibuprofen (IBU) by melt adsorption or melt granulation and evaluated the particle size, physical properties and crystallinity of granules. Compared with melt granulation using DCPD, melt adsorption can be performed over a wide range of 14 to 70% for the ratio of molten components. Moreover, the particle size; d50 of obtained granules was 100–200 µm, and these physical properties showed good flowability and roundness. The process of melt adsorption did not affect the crystalline form of IBU. Therefore, the present study has demonstrated for the first time that melt adsorption using a hydrophobic material, GM or SA, has the potential capability to control the particle size of granules and offers the possibility of application as a novel controlled release technique.


Kai Shiino1), Yukari Fujinami1), Shin-ichiro Kimura1), Yasunori Iwao1), Shuji Noguchi2), Shigeru Itai1)

1) Department of Pharmaceutical Engineering, School of Pharmaceutical Sciences, University of Shizuoka 2) Faculty of Pharmaceutical Sciences, Toho University
Senden Released on J-STAGE 20170801

Adobe Acrobat Document 469.9 KB

You might also like