Determination and understanding of lead-lag between in-line NIR tablet press feed frame and off-line NIR tablet measurements

The influence of different tableting process parameters on lead-lag was studied by collecting in-line near-infrared (NIR) spectra in the filling chamber of the tablet press feed frame and off-line NIR tablet data. Lead-lag is defined as the difference in time and API concentration between the measured in-line feed frame NIR response and the off-line NIR tablet data. Lead-lag results from the product formulation blend undergoing additional mixing after passing the NIR probe inside the feed frame, before being filled into the dies of the tablet press.

A design of experiments (DoE) was performed to evaluate the effect of the tableting process factors paddle speed, turret speed, overfill level, paddle speed ratio and feed frame type upon lead-lag. Paddle speed and turret speed were identified as the only tableting parameters affecting lead-lag. Lead-lag decreased with increasing paddle speed or turret speed and became negligible at high paddle speed and high turret speed. Overfill level, paddle speed ratio and feed frame type did not affect lead-lag, suggesting that the amount and the trajectory of the recirculating powder in the feed frame did not significantly vary and hence influence the lead-lag within the examined process factor ranges.

Finally, a methodology was developed using the in-line feed frame NIR measurements for the continuous monitoring and control of blend potency and tablet content uniformity. Tablet diversion should start when the in-line feed frame monitored blend potency exceeds the predefined control limits and can discontinue when this blend potency is again within the control limits for a duration equal to the lead-lag time. A combination of continuous blend potency monitoring inside the feed frame and in-process tablet weight control allows real-time tablet content uniformity assurance. Although the findings of this study are restricted to the specific equipment, tableting parameter ranges and product formulation used, the suggested approach for lead-lag determination and continuous tablet content uniformity monitoring can be applied to any rotary tablet press and product formulation.

See the article

Michiel Peeters, Elisabeth Peeters, Daan Van Hauwermeiren, Giuseppe Cogoni, Yang Liu, Thomas De Beer,
Determination and understanding of lead-lag between in-line NIR tablet press feed frame and off-line NIR tablet measurements,
International Journal of Pharmaceutics, 2021, 121328, ISSN 0378-5173,
https://doi.org/10.1016/j.ijpharm.2021.121328.